WTB WTB truss rod key

[Muovinen]

I don't know if one key would fit both the S100 and S300 I own? For now I need the key for the S100. The Gibson key I have was too large.

It doesn't have to be original so a link to some shop selling replacements would also be appreciated It's usually hard to find keys with American measurements in Finland.

 

[Jeff]

Stewart MacDonald has truss rod wrenches in abundance.

http://www.stewmac.com/shop/Truss_rods.html,

I don't think a specialty wrench is necessary, most any nut driver in the correct size should work. I think 1/4 inch is the correct size. http://www.sears.com/tools-hand-tools-n ... T_REC_PRED

 

[fronobulax]

The tool Guild sold for a '71 JS II was nothing more than a branded 1/4" nut driver.

All of the discussions I have seen concerning the 70's Guilds suggests a one quarter inch nut driver should be able to make truss rod adjustments.

 

[Default]

Sometimes, the wall on the nutdriver can be a little thick and I found that 1/4 inch brake bleeder wrench works just fine.

 

[Muovinen]

Thanks for the info guys! I think I'll be able to find a suitable tool somewhere. A lot of the problems I had with the S100 went away just by adjusting the bridge but the neck needs a little bit of work too. Then it will be perfect!