DeArmond Hammer
Member
The person who sold me this end pin said it was from a 1964 Guild F-20. I hoped that it would fit my 1977 D-50, but it was too big to fit all the way into the hole. By my caliper's measurements the shaft on this pin is 20mm long and tapers from 8.0 mm to 6.9 mm.
I'll sell for $12 including Paypal and domestic postage. If you return it in unchanged condition within a week of receiving it, I'll refund $10.
Since it's supposedly a Guild pin, I'm listing here before anywhere else.
I'll sell for $12 including Paypal and domestic postage. If you return it in unchanged condition within a week of receiving it, I'll refund $10.
Since it's supposedly a Guild pin, I'm listing here before anywhere else.
Last edited: