guitarjamman
Junior Member
Bought a K&K Pure Western Mini to replace the current sound hole pickup (Lace) I had installed previously. Followed the instructions and all went without a hitch....My question revolves around placing the rear nut to the correct depth on the jack?
There are two nuts to tighten on the jack, one holds tight against the inside of the guitar and the second holds tight against the outside of the guitar. The outside one is simple to tighten correctly but the inside one keeps vibrating loose and makes quite a racket. Can't seem to tighten it to the right spot and have it hold. When it gets going, it sounds like I have a loose brace!
Any tips from you guys to get it to the right thread before installing it?
Thanks
There are two nuts to tighten on the jack, one holds tight against the inside of the guitar and the second holds tight against the outside of the guitar. The outside one is simple to tighten correctly but the inside one keeps vibrating loose and makes quite a racket. Can't seem to tighten it to the right spot and have it hold. When it gets going, it sounds like I have a loose brace!
Any tips from you guys to get it to the right thread before installing it?
Thanks