Wiring for NS "Dynasonics"?
- Thread starter X-170AB
- Start date
Nuuska
Enlightened Member
Hello
In your picture the black wire is connected to ground - so black it is then. White is "hot".
But because the coil ends in corners are each non-grounded - I would wire it with microphone cable - connect the shield to ground and the two wires each in coil end. This way there would be more possibilities for different pup-combinations. Like phase-reverse - which actually is polarity-reverse. It would also allow two pup series-connection if desired - and leaving the pup shells grounded all the time no matter how you switch.
In your picture the black wire is connected to ground - so black it is then. White is "hot".
But because the coil ends in corners are each non-grounded - I would wire it with microphone cable - connect the shield to ground and the two wires each in coil end. This way there would be more possibilities for different pup-combinations. Like phase-reverse - which actually is polarity-reverse. It would also allow two pup series-connection if desired - and leaving the pup shells grounded all the time no matter how you switch.
Nuuska,
Hello up there in Finland! Thanks for your reply. I should probably be more specific; what I'm actually wanting to do is replace the NS Dynasonic with a TV Jones T-Armond. Want to be sure I'm connecting the right pickup wire to the correct wire on the harness.
Hello up there in Finland! Thanks for your reply. I should probably be more specific; what I'm actually wanting to do is replace the NS Dynasonic with a TV Jones T-Armond. Want to be sure I'm connecting the right pickup wire to the correct wire on the harness.