lungimsam
Senior Member
- Joined
- Oct 1, 2011
- Messages
- 2,614
- Reaction score
- 1,668
- Guild Total
- 2
1. I cannot get the G side lower than the E side. Usually have 7/64 on the E side and 5/64 on the G side.
G side action adjustment screw doesn’t make contact with bridge plate once you get down to 6/64. Any ideas? If I remove that grub screw the action stays at 6/64.
2. Strings have also become too close again to the pick up housing at my usual preferred height as described above. I have to lower the pole pieces below the housing so it’s not over driven. Can I just remove that black mounting ring and leave the pick up flush to the face?
G side action adjustment screw doesn’t make contact with bridge plate once you get down to 6/64. Any ideas? If I remove that grub screw the action stays at 6/64.
2. Strings have also become too close again to the pick up housing at my usual preferred height as described above. I have to lower the pole pieces below the housing so it’s not over driven. Can I just remove that black mounting ring and leave the pick up flush to the face?